It's an early stock CJ-5, 6 volt, F-head, T-90 and the D-18 with an inch and 1/4 intermediate shaft, and an overdrive. Just like a 3B but with a different body...
It's surprisingly quiet in all gears, both 2WD and 4WD. Shifts smooth with no grinding. Never been rebuilt. Shows about 47K miles on the odometer, which still works.
But put it in low range, 4WD, hubs free, and it starts to get noisy, But no noise that may be a broken tooth. I know the low range gears are straight-cut so some noise is expected.
As you might expect the noise rises in intensity on acceleration and decreases when off the gas, doesn't really change otherwise, doesn't go away when coasting even. Of course we are talking maybe 10 mph in third, low range. By then it's quite a howl. You can almost feel it. It's been like this for a long time.
I've looked at the line drawings of the D-18 and can't figure just what is coming under load for this noise to appear only in Low Range, and quiet in 2WD and 4WD High Range.
I used to drive this jeep around the ranch when I was a kid, mostly in low range because I liked the gear noise!
Now I'm not so fond of it.
I'm planning to take the bottom cover off and have a look, and if need be I'll rebuild it when I replace the clutch this winter.
Maybe just worn square cut gears? What else to look for?
Maybe the intermediate shaft? But it's quiet otherwise, quieter than the 3A which has been rebuilt.
Thanks!
Randy