Leave the wires attached to the cap, leave the cap attached to the distributor....remove one wire at the spark plug end and hold the metal end of that wire about 1/8" from the block while cranking, with the ignition "on".. Hold the wire with something that is insulated or you may get the shock!
If your plug wires have rubber cups on the spark plug end then remove a plug, re-attach the wire to the plug, and then hold the metal part of the plug against the block and watch for a spark at the electrode.
You may have to do this inside or in the shade to see the spark...
Rotor should rotate counter-clockwise..you can see this with the cap off, and you should see the points open a little....just .020 inch...