The CJ3A Page CJ3B.info

Author Topic: Distributer shaft length  (Read 10992 times)

0 Members and 1 Guest are viewing this topic.

Offline Gunslinger

  • Flatfender Master
  • *****
  • Posts: 942
  • Karma: +0/-0
  • Cj3a, M38A1,
    • View Profile
Re: Distributer shaft length
« Reply #30 on: March 29, 2014, 10:24:55 AM »
Mine is converted to 12 volt, I like it as I can use some of the modern accessories easier, ie winches and lights.  I used a coil with an internal resistor, this drops the voltage to 8 volts.  Make sure you change your head lights as well, and yes it does make the starter really whirr!  I've had this conversion for about 3 years now and have not had a problem with the starter burning out. 
Climbs trees, hides in the long grass, hangs out with wet dogs...

Offline Carls_jeep

  • Flatfender Master
  • *****
  • Posts: 1746
  • Karma: +0/-0
  • ...
    • View Profile
Re: Distributer shaft length
« Reply #31 on: March 29, 2014, 11:38:50 AM »
My Jeep is 12v also and I have no starter problems. If your planning to use a winch and other high amp draw equipment get the highest amp alt. you can. I have a 60A alt and it helps with the winch use.

Offline macrisel

  • Flatfender Master
  • *****
  • Posts: 639
  • Karma: +0/-0
  • Always in the middle of a project
    • View Profile
Re: Distributer shaft length
« Reply #32 on: March 31, 2014, 09:56:10 AM »
Well.........I'll keep it 6 volt for now.  I took great pains in trying to keep this jeep original so I'll fly that course for now.  Maybe sometime in the future I'll switch it over to 12 volt if I change how I use the jeep.  I'm not planning on adding any modern accessories (radio, winch, lights) right now so I should be okay.  In addition, I've already bought a 6 volt battery tender and I would hate for that to go to waste.

However..........for my next Willys project sitting in the shed I can make no promises about keeping it original..... ;)

Offline macrisel

  • Flatfender Master
  • *****
  • Posts: 639
  • Karma: +0/-0
  • Always in the middle of a project
    • View Profile
Re: Distributer shaft length
« Reply #33 on: March 31, 2014, 10:12:39 AM »
On a side note, I really appreciate all the help everyone gave me on this.  It took a while to figure it out and I was scratching my head several times.

Everytime I open the hood on the jeep for something, it seems is isn't long before I'm also opening the laptop and pulling up this forum.

Thanks again to a great bunch of guys.