Ok guys I've read the wiring diagram and other than the lights which aren't important because I am waiting on the new switch I have all the wire run to the AMM gauge, fuel gauge, etc. My problem however is this cj3a is a 12V conversion. Alternator, 12V battery, etc. I run the positive cable from the battery to the starter and a wire from the starter to the AMM gauge.....the jeep cranks a runs fine as long as the AMM gauge is hanging out of the dash...if I put the AMM gauge in the dash and start to crank it the gauge starts arching fire off the dash. Is the AMM gauge supposed to have a rubber ring or something to keep it from doing this???

I have ordered a whole new set of 12V gauges from Kaiser/Willys but I would like to make sure the wiring is correct and if the gauge is just faulty.

athawk11 wrote on 05/19/16 at 18:04:30:


Sounds like you got yourself a melted wire problem just like this one had before I got a hold of it. It's actually a customer of mines. He is restoring it but does not want to fork out the moolah for a new wiring harness...the originally was toast. So I'm color coding wire and doing things myself. Considering there really isn't much wiring in these old cj3's it's fairly simple! Thanks for the tip and that explains my problem completely. There were no insulators on this gauge at all which is causing my arching problem! Thanks man!