The CJ3A Page CJ3B.info

Author Topic: Allignment  (Read 7215 times)

0 Members and 1 Guest are viewing this topic.

Offline macrisel

  • Flatfender Master
  • *****
  • Posts: 639
  • Karma: +0/-0
  • Always in the middle of a project
    • View Profile
Re: Allignment
« Reply #15 on: October 28, 2011, 11:28:45 AM »
"All alignment adjustments should be made with the normal load in the vehicle while sitting on the ground."

This would be why alignment machines have sections under the front wheels that swivel to allow the front wheels to move easily......correct?

Offline Bob W

  • Flatfender Master
  • *****
  • Posts: 2309
  • Karma: +0/-0
    • View Profile
Re: Allignment
« Reply #16 on: October 28, 2011, 04:21:05 PM »
The plates move in all directions to allow the tires to find their normal position. This can be accomplished at home by rolling the vehicle back and forth after lowering it to the ground.

Alignment rack plates also swivel because it is necessary to swing the wheels left and right to measure caster angle.
Bob W