That settles it then I'll go with top shims only.
? For a 1949 the shims should be evenly split between the top and bottom.
Bob, I am a lil confused about "evenly split"... as I see it to be the shims dial in the knuckle for pre-load and centering, These shims take up errors in machining that evidently Old Man Willies dialed in after a bit, and went with the 50 some thousands extra meat on the bottom knuckle,
Now these shims can be various thickness, So simply evenly splitting them by number ? dont add up, ?? usually the shim thickness can vary from super thin, ,005, to .030
If your concerned about this a alignment tool needs to be fabricated, otherwise its a guessing game,
Regardless, if the thing was happy for years with the shims where they where, leave it the way it was, For sure on the bottom, and dial in the pre load from the top,