Rick, I have been following your engine issues. I know you feel my pain�and it�s my pain on steroids.
Glen, The last time I checked was last year before the FCT. Compression was in the High 70s, so I knew something was a little tired.
Tom, I really didn�t know I had broken rings until I pulled the pistons. Because of my low compression readings along with a leak down test, I made a semi�non--educated guess that they were worn or broken.
The seal installation went well. I am using the rope seal.
The disadvantage you have when installing the seal with the engine in place� You need to pull the new seal over the crank shaft. This is difficult enough because the Sneaky Pete style tools don�t work very well. Added to this, you�re on your back with poor lighting, and very little space to maneuver. It�s nearly impossible to cut the seal to the proper length once you have it pulled over the crank. And through it all, you have oil constantly dripping on your face.
The advantage to doing the seal without the crankshaft in the way�You can properly pack the seal in the channel and you have added room to cut the seal to the correct length.
Again, I was willing to try the Sneaky Pete approach because of the added effort required to pull the engine. But as you know from the SDR, I was embarrassed by this failure�plus I�m tired of wiping the oil splash back from the underside of my Willys. I don't mind wiping the mud and dirt off. It comes off way easier than oil.

Tim