Lots of new updates to share on the Titan's progress. I got the new piston rings in. I checked the ring gap in the bores and that was perfect, a tad wider than an 1/8".

New ring versus old.

I had to file the corners off because these rings are pinned on the pistons. You can see the pins here. And this rings are really easy to put on, probably easier than the automotive ones.

And viola! Pistons are bark in there homes. I so can't wait to fire this thing up!


And I also got in the missing carb piece. I got a reproduction cap for it too and made a needle valve for it out of a 3/8" bolt and an old water spigot knob. At least these reproductions are exact, it even comes with the part number and IHC logo cast into it just like the originals!



And then to top it all off, I figured out what all the original writing says on the fenders and shift lever. Got to love the old time warnings. No mention whatsoever of where you shouldn't put hands or feet!

This one says "Wait to shift gears until clutch stops"

"Chains too loose may break sprockets
Shift axle eccentrics to tighten chains
See instruction book"

This is the hardest to read, but it says:
"Operator should enter seat
before shifting clutch lever"
