The CJ3A Page Forum › Willys CJ-3A Technical Knowledge Base › Tech Talk › Transmission crossmember and pedal dimensions
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Print
Normal Topic Transmission crossmember and pedal dimensions (Read 675 times)
 
Buildinghippy
Project Jeep
*
Offline


Plays With Jeeps

Posts: 21
Location: MI
Joined: 01/31/13
Gender: Male
Transmission crossmember and pedal dimensions
05/15/13 at 22:23:48
Print Post  
I have  searched this page and the 2a site and I could not find what I was looking for. Tryin to find to location of both, so that I can check that my crossmember is in the right place and to figure out where the pedals go. Looking for the dimensions as pulled off the rearmost crossmember. Thanks in advance for all the help.
  
1950 CJ3A, cj2a windshild, ford 289
Back to top
 
IP Logged
 
athawk11
YaBB Administrator
Owner Member 2012
2016 Sponsor Member
2015 Sponsor Member
*****
Offline


1949 CJ3A

Posts: 2771
Location: Arvada, Colorado
Joined: 01/26/11
Gender: Male
Re: Transmission crossmember and pedal dimensions
Reply #1 - 05/15/13 at 23:05:55
Print Post  
BH,

Are you looking to position the Tranny/TC support?  If so, I found it easier and more accurate to measure from the center of the rear leaf spring mount, forward, to the Tranny/TC cross member mounting holes.  They are at: 20 1/2" and 23" to center.

If I misunderstand what you are trying to measure, post back and I run out and do it again.

Tim
« Last Edit: 05/15/13 at 23:10:16 by athawk11 »  
2-1949 CJ3A 
1-1946 CJ2A
Back to top
 
IP Logged
 
Buildinghippy
Project Jeep
*
Offline


Plays With Jeeps

Posts: 21
Location: MI
Joined: 01/31/13
Gender: Male
Re: Transmission crossmember and pedal dimensions
Reply #2 - 05/15/13 at 23:36:27
Print Post  
Tim thank you for the help, that was just what I needed.
  
1950 CJ3A, cj2a windshild, ford 289
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Print
‹ Previous Topic | Next Topic ›
Bookmarks: Facebook Google Google+ Linked in Twitter Yahoo
 
  « Board Index ‹ Board Top  

The CJ3A Page Forum » Powered by YaBB 2.6.11!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge