The CJ3A Page CJ3B.info

Author Topic: Speedo reads at 1/2 speed  (Read 1003 times)

0 Members and 1 Guest are viewing this topic.

Offline Barry L

  • Project Jeep (Newbie)
  • *
  • Posts: 5
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Speedo reads at 1/2 speed
« on: May 08, 2024, 09:09:13 PM »
Any feed back on this speedo on a CJ3a.    Purchased with a complete gage set but reads at 1/2 speed against my GPS.  0-60 with MS 39021-2 label.   Am running 16" NDT's    Not sure if the Dana 44 is a 4.27 or 5.38 but still would not make that big a difference.   Any ideas would be appreciated

Offline tow hook

  • Project Jeep (Newbie)
  • *
  • Posts: 15
  • Karma: +1/-0
  • Still Plays With Jeeps
    • View Profile
Re: Speedo reads at 1/2 speed
« Reply #1 on: September 11, 2026, 11:16:14 AM »
Any feed back on this speedo on a CJ3a.    Purchased with a complete gage set but reads at 1/2 speed against my GPS.  0-60 with MS 39021-2 label.   Am running 16" NDT's    Not sure if the Dana 44 is a 4.27 or 5.38 but still would not make that big a difference.   Any ideas would be appreciated

 i had the same issue.... i found that my cable was to long and bound up,, the needle would hand up and stick. the took off a 1/8" at a time ( down at the t case ) till it was right. and checked it with gps as well