The CJ3A Page CJ3B.info
« previous next »
Pages: [1]   Go Down

Author Topic: Cross over tube  (Read 1314 times)

0 Members and 1 Guest are viewing this topic.

Offline Chris P

  • Project Jeep (Newbie)
  • *
  • Posts: 10
  • Karma: +0/-0
    • View Profile
Cross over tube
« on: March 07, 2022, 10:13:46 PM »
Hi everyone!
I am looking for a cross over tube for my 1948 2A.
I found this one which seems correct but it hasn’t the depression that I found in most tubes (pic #2)
 #1


#2


Just wondering if #1 is a CJ3A tube or some kind of repro.
Thanks for your help
Chris
« Last Edit: March 08, 2022, 08:42:47 AM by Chris P »
Logged
Chris

1943 Ford G.P.W (located in Argentina)
1944 Willys MB (located in Argentina)
1948 Willys CJ2A (located in Mexico)
1956 Willys CJ3B (located in Mexico)
New: 1957 Willys CJ5 (located in Mexico)

Offline athawk11

  • SMF Administrator
  • Flatfender Master
  • *****
  • Posts: 2818
  • Karma: +0/-1
  • 1949 CJ3A
    • View Profile
Re: Cross over tube
« Reply #1 on: March 07, 2022, 10:53:13 PM »
The indent goes away during CJ3A production.  The radiator rod support (the primary reason for the indent) was no longer needed when the radiator switched from bottom mount to side mount on the CJ3A.
Logged
2-1949 CJ3As
1-1946 CJ2A

Offline Chris P

  • Project Jeep (Newbie)
  • *
  • Posts: 10
  • Karma: +0/-0
    • View Profile
Re: Cross over tube
« Reply #2 on: March 08, 2022, 08:44:08 AM »
That makes total sense. Thanks for your answer! Cheers
Logged
Chris

1943 Ford G.P.W (located in Argentina)
1944 Willys MB (located in Argentina)
1948 Willys CJ2A (located in Mexico)
1956 Willys CJ3B (located in Mexico)
New: 1957 Willys CJ5 (located in Mexico)
Pages: [1]   Go Up
« previous next »