The CJ3A Page CJ3B.info
« previous next »
Pages: [1]   Go Down

Author Topic: wiring harness  (Read 1972 times)

0 Members and 1 Guest are viewing this topic.

Offline brotherdavid

  • Project Jeep (Newbie)
  • *
  • Posts: 32
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
wiring harness
« on: June 16, 2011, 10:18:47 PM »
hey guys i was just wondering. I got my new wiring harness from walcks for my 53 cj-3a and was wondering if the 2 wires that go to the master cylinder switch if it matters wich one the hot wire goes to? I noticed the one wire has power to it all the time even when the ignition switch is off, I asume it does so brake light will work even when ignition is off. THANKS
Logged

Offline rocketeer

  • Flatfender Master
  • *****
  • Posts: 1328
  • Karma: +0/-0
  • Support Our Troops.
    • View Profile
Re: wiring harness
« Reply #1 on: June 16, 2011, 11:20:57 PM »
Makes no difference which wire goes to which post on the brake light switch. The switch simply connects the two pins to complete the circuit when the pedal is depressed.

This dimmer switch is the replacement type and yours may be different. The tang with two rivets should, however, be the power tang.





Larry
Logged

Offline Gunslinger

  • Flatfender Master
  • *****
  • Posts: 942
  • Karma: +0/-0
  • Cj3a, M38A1,
    • View Profile
Re: wiring harness
« Reply #2 on: June 17, 2011, 01:40:00 PM »
Larry,
Nice description and photos.
Logged
Climbs trees, hides in the long grass, hangs out with wet dogs...

Offline mud pie

  • Flatfender Enthusiast
  • ***
  • Posts: 143
  • Karma: +0/-0
  • Once a Marine....
    • View Profile
Re: wiring harness
« Reply #3 on: June 20, 2011, 09:53:17 AM »
Copied/pasted them pics !!  One of the most helpful pics to date, thanks !
Logged
1953 CJ-3A
Pages: [1]   Go Up
« previous next »