The CJ3A Page CJ3B.info
« previous next »
Pages: [1]   Go Down

Author Topic: Gasket or Silicone Gasket Maker  (Read 1985 times)

0 Members and 1 Guest are viewing this topic.

Offline athawk11

  • SMF Administrator
  • Flatfender Master
  • *****
  • Posts: 2818
  • Karma: +0/-1
  • 1949 CJ3A
    • View Profile
Gasket or Silicone Gasket Maker
« on: June 02, 2011, 12:59:29 PM »
Thoughts on Gasket  vs. Silicone Gasket Maker for the timing chain cover?

(GPW chain drive motor with Thrust Stud on inside of cover)

I have read some posts where original thickness of the gasket is critical to good function.  How about the timing chain cover?

Tim

Logged
2-1949 CJ3As
1-1946 CJ2A

Offline p3ferris

  • Willys Guru
  • ****
  • Posts: 249
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: Gasket or Silicone Gasket Maker
« Reply #1 on: June 02, 2011, 05:56:10 PM »
use gaskets  you will not have a leak and have to do it over soon
Logged

Offline Carls_jeep

  • Flatfender Master
  • *****
  • Posts: 1746
  • Karma: +0/-0
  • ...
    • View Profile
Re: Gasket or Silicone Gasket Maker
« Reply #2 on: June 02, 2011, 07:44:24 PM »
Use a gasket and a thin film of RTV on both sides of the gasket.
Logged

Offline mud pie

  • Flatfender Enthusiast
  • ***
  • Posts: 143
  • Karma: +0/-0
  • Once a Marine....
    • View Profile
Re: Gasket or Silicone Gasket Maker
« Reply #3 on: June 03, 2011, 08:03:15 AM »
I always thought the general rule of thumb was to use RTV only on one side of a gasket, preferably on the part that comes off (cover), as it makes it possible to remove the cover later on and is easier to clean up. If you put RTV on both sides, you are essentially "gluing" them together, which makes removal all that much harder.
Logged
1953 CJ-3A
Pages: [1]   Go Up
« previous next »