The CJ3A Page CJ3B.info
« previous next »
Pages: [1]   Go Down

Author Topic: Add-a-leaf  (Read 2193 times)

0 Members and 1 Guest are viewing this topic.

Offline Howitser

  • Project Jeep (Newbie)
  • *
  • Posts: 28
  • Karma: +0/-0
  • Yep, Frankenjeep !
    • View Profile
Add-a-leaf
« on: May 09, 2011, 11:02:36 AM »
Hi,  Has anyone used "rough country add-a-leaf" to gain a little lift?
Logged
Howie

Offline Gunslinger

  • Flatfender Master
  • *****
  • Posts: 942
  • Karma: +0/-0
  • Cj3a, M38A1,
    • View Profile
Re: Add-a-leaf
« Reply #1 on: May 09, 2011, 11:27:28 PM »
Is that the single leaf that is supposed to bolt under the spring pack?  I bought a set of those but the bolt hole was too small in the spring pack and I had to try to drill them out.  Used up a couple bits and quit.  
Logged
Climbs trees, hides in the long grass, hangs out with wet dogs...

Offline p3ferris

  • Willys Guru
  • ****
  • Posts: 249
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: Add-a-leaf
« Reply #2 on: May 10, 2011, 05:32:19 PM »
I have not used that brand.  I have used others and I have one in use now on my van  gained 2 inches.  I have a lot of weight.
Logged

Offline Chasm

  • Flatfender Enthusiast
  • ***
  • Posts: 135
  • Karma: +0/-0
  • Bald Heads for Flat Heads
    • View Profile
Re: Add-a-leaf
« Reply #3 on: May 17, 2011, 03:06:21 PM »
I bought a new set of leaf springs all the way 'round from Walck's. After installation, I was surprised at the amount of "lift" I got compared to the tired old springs. The quality of Carl's USA made springs is excellent. Old Yeller sits level now and has plenty of room for the 700x16 NDCC tires!
Logged
Jeeps are like potato chips. It's hard to stop at just one!
Pages: [1]   Go Up
« previous next »