The CJ3A Page CJ3B.info
« previous next »
Pages: [1]   Go Down

Author Topic: Rear Brake Lines  (Read 5017 times)

0 Members and 1 Guest are viewing this topic.

Offline JimVillers

  • Willys Fan
  • **
  • Posts: 79
  • Karma: +0/-0
  • Making progress on a disposable CJ3A?
    • View Profile
Rear Brake Lines
« on: November 21, 2015, 11:42:56 AM »
I am trying to figure out the attachment of the rear brake line that goes across the rear axle.  It looks like there should be a bolt hole in the top of the differential but I cannot find one. 

The preformed brake lines did not come with clips.  I would think that it should have a clip that goes behind a cover bolt (like the front line) and it looks like it should have three bands to secure the line to the axle.

Can someone post a picture of the clips or straps or what ever is correct.
Logged
Jim Villers
Virginia Beach, VA
A very Rusted 1950 CJ-3A .... Making progress.

Offline Kirkski

  • Flatfender Master
  • *****
  • Posts: 526
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: Rear Brake Lines
« Reply #1 on: November 21, 2015, 09:32:03 PM »
Here is a pic, sorry its so grainy. But there is a brackets that has a tapped hole in it for a screw
Logged
'52 CJ-3A

Offline athawk11

  • SMF Administrator
  • Flatfender Master
  • *****
  • Posts: 2818
  • Karma: +0/-1
  • 1949 CJ3A
    • View Profile
Re: Rear Brake Lines
« Reply #2 on: November 21, 2015, 11:11:34 PM »
I was missing my bracket too.  It's a pretty easy bracket to make if you have a little L-angle laying around.  Not perfect, but it works...



Tim
Logged
2-1949 CJ3As
1-1946 CJ2A

Offline JimVillers

  • Willys Fan
  • **
  • Posts: 79
  • Karma: +0/-0
  • Making progress on a disposable CJ3A?
    • View Profile
Re: Rear Brake Lines
« Reply #3 on: November 22, 2015, 07:37:15 PM »
Tim .... What is the clamp around the axle?� Is it correct?� Where did you get it?

I fabricated a simple bracket for the brass fitting.� I just need the clamps.
« Last Edit: November 22, 2015, 07:38:10 PM by JimVillers »
Logged
Jim Villers
Virginia Beach, VA
A very Rusted 1950 CJ-3A .... Making progress.

Offline Ryan_M

  • Flatfender Master
  • *****
  • Posts: 1704
  • Karma: +0/-0
    • View Profile
Re: Rear Brake Lines
« Reply #4 on: November 22, 2015, 07:56:43 PM »
I have these on my 3A. Not sure if they are original but I believe they are. I've found them on other Willys too.

« Last Edit: November 22, 2015, 07:56:59 PM by Ryan_M »
Logged
Current:
'49 CJ3A
'51 CJ3A
'42 Willys MB-T
'47 Bantam T3-C
Previous:
'46 2A
'51 3A
'52 3A
'52 M38
'54 3B
East Coast Wi

Offline Bob W

  • Flatfender Master
  • *****
  • Posts: 2309
  • Karma: +0/-0
    • View Profile
Re: Rear Brake Lines
« Reply #5 on: November 22, 2015, 08:27:23 PM »
Early CJ-3As had clamps, like Tim's photo. Later CJ-3As used the clips like Ryan's photo.
Logged
Bob W

Offline athawk11

  • SMF Administrator
  • Flatfender Master
  • *****
  • Posts: 2818
  • Karma: +0/-1
  • 1949 CJ3A
    • View Profile
Re: Rear Brake Lines
« Reply #6 on: November 23, 2015, 07:30:57 PM »
Thanks Bob.� I didn't know about the change.� The clips in Ryan's photos look pretty slick.

Jim, the clamps shown in my photo were included with the brake line kit I purchased from Walcks.� This kit is for the CJ2A and early CJ3A.

Your photo shows a Dana 41 rear axle which is consistent with early 3As.

Tim
« Last Edit: November 23, 2015, 07:33:49 PM by athawk11 »
Logged
2-1949 CJ3As
1-1946 CJ2A

Offline JimVillers

  • Willys Fan
  • **
  • Posts: 79
  • Karma: +0/-0
  • Making progress on a disposable CJ3A?
    • View Profile
Re: Rear Brake Lines
« Reply #7 on: November 24, 2015, 05:47:40 PM »
Tim ... I just figured out that the rear end was a Dana 41 when the rear cover gasket did not fit. 

It does have tapered axles like the Dana 44.  I wonder if a prior owner swapped the axles for some reason.
Logged
Jim Villers
Virginia Beach, VA
A very Rusted 1950 CJ-3A .... Making progress.

Offline athawk11

  • SMF Administrator
  • Flatfender Master
  • *****
  • Posts: 2818
  • Karma: +0/-1
  • 1949 CJ3A
    • View Profile
Re: Rear Brake Lines
« Reply #8 on: November 24, 2015, 08:14:12 PM »
Jim,
What serial number is your 3A?

Tim
Logged
2-1949 CJ3As
1-1946 CJ2A

Offline JimVillers

  • Willys Fan
  • **
  • Posts: 79
  • Karma: +0/-0
  • Making progress on a disposable CJ3A?
    • View Profile
Re: Rear Brake Lines
« Reply #9 on: November 28, 2015, 04:44:15 PM »
Tim ... My Jeep is CJ-3A 46300.
Logged
Jim Villers
Virginia Beach, VA
A very Rusted 1950 CJ-3A .... Making progress.

Offline athawk11

  • SMF Administrator
  • Flatfender Master
  • *****
  • Posts: 2818
  • Karma: +0/-1
  • 1949 CJ3A
    • View Profile
Re: Rear Brake Lines
« Reply #10 on: November 28, 2015, 08:49:52 PM »
Based on your SN, your Willys was likely made in March or April 1950.  The Dana 41 is correct for this time frame.  The Dana 44 starts showing up on the 3A in late 1950.

Tim
Logged
2-1949 CJ3As
1-1946 CJ2A
Pages: [1]   Go Up
« previous next »