I started by going at it with polish. �This wasn't working very well. �The original lacquer coating had to be removed.
I wet sanded it with 1500 grit paper, then 3000 grit, then automotive polish, then a couple minutes at a buffer wheel. Cleaned it, then rattle can clear coat lacquer to protect it.
I was careful with the label. �I used a very small sanding block on the embossed lettering. I didn't want to lose the paint around the letters. �
It took about 5 hours on New Years Day. �Too cold to do much else. �
Thanks to everyone for taking a peek.

Tim