The CJ3A Page CJ3B.info

Author Topic: jeep  (Read 2521 times)

0 Members and 1 Guest are viewing this topic.

Offline Dennisanvil

  • Willys Fan
  • **
  • Posts: 55
  • Karma: +0/-0
  • Still Plays With Jeeps / blacksmith/ woodworking
    • View Profile
jeep
« on: August 16, 2013, 12:03:10 PM »
I am getting ready to go to the fall reunion next month.{ see the fall reunion page on the cj2a page} my question how would cover the shift levers of your jeep to kept water out of the shifts as you are towing on the trailer. the jeep is store in the willy barn all the other time?
dennis

Offline johnrb3b

  • SMF Administrator
  • Flatfender Master
  • *****
  • Posts: 906
  • Karma: +0/-0
  • No such thing as too many Jeeps - well maybe
    • View Profile
    • Jeeps and stuff
Re: jeep
« Reply #1 on: August 16, 2013, 12:52:56 PM »
Big plastic bag and duct tape.
1946 2A - - - 1949 me - older than most of my Jeeps
1954 3B - - - 1957 Wagon - - - 2010 4-door JK
past Jeeps ---> '54 3B - no tub --- '59 3B - no engine
past addiction - VW ---> '69 bus --- '70 camper

Offline garage gnome

  • Flatfender Master
  • *****
  • Posts: 1947
  • Karma: +0/-0
  • Rustologist
    • View Profile
Re: jeep
« Reply #2 on: August 16, 2013, 09:52:09 PM »
If you have good boots on them, you shouldn't have to worry.
Nate in Western MA 1953 3A #3268, The Jalopy, '47 2A Wheelin' rig, '49 3A, #37071, unmolested, bone stock named Ted

Offline Carls_jeep

  • Flatfender Master
  • *****
  • Posts: 1746
  • Karma: +0/-0
  • ...
    • View Profile
Re: jeep
« Reply #3 on: August 17, 2013, 10:12:46 AM »
Sooo, it's a garage queen?

Offline Dennisanvil

  • Willys Fan
  • **
  • Posts: 55
  • Karma: +0/-0
  • Still Plays With Jeeps / blacksmith/ woodworking
    • View Profile
Re: jeep
« Reply #4 on: August 17, 2013, 10:52:30 AM »
I have leather boots on , they willnt stop water from go a long side of the shift lever. leather boots don't seal anything from water.
as to the post of a garage queen I do take the jeep out and drive it but not in the rain. I  didn't want it to get smaller. when towing the jeep the top off of the jeep.
I hope that this will tell all???????
dennis

Offline Carls_jeep

  • Flatfender Master
  • *****
  • Posts: 1746
  • Karma: +0/-0
  • ...
    • View Profile
Re: jeep
« Reply #5 on: August 18, 2013, 01:31:52 AM »
Dennis, you could get the rubber boots and put them on under the leather boots and that would keep the water out.

I hope you use a trailer to tow the Jeep but if you don't please remove the drive shafts front and rear and DON'T drive over 55 mph. These Jeeps are not made to tow at highway speeds. Read the military manuals about towing the Jeep and the Army Jeeps were geared higher than our CJ's.

Offline Dennisanvil

  • Willys Fan
  • **
  • Posts: 55
  • Karma: +0/-0
  • Still Plays With Jeeps / blacksmith/ woodworking
    • View Profile
Re: jeep
« Reply #6 on: August 18, 2013, 09:09:49 AM »
I pull a flat trailer with the jeep on it. that is why I take the top off. it look like the ideal is duct tape and plastic it is going to be. if I start today I could make it about a week drive there. I don't know if today rubber boot are any good.
dennis

Offline Bob W

  • Flatfender Master
  • *****
  • Posts: 2309
  • Karma: +0/-0
    • View Profile
Re: jeep
« Reply #7 on: August 18, 2013, 07:18:17 PM »
Since the transfer case levers are external you don't need to worry about them. For the transmission - use an M-38 boot. It was designed to be waterproof and attaches with two hose clamps.
Bob W