The CJ3A Page CJ3B.info

Author Topic: Don't knock it until you have tried it  (Read 2552 times)

0 Members and 1 Guest are viewing this topic.

Offline Jesse

  • Willys Guru
  • ****
  • Posts: 298
  • Karma: +0/-0
    • View Profile
Don't knock it until you have tried it
« on: October 04, 2012, 10:46:14 AM »
So I know people get really mad about these so called 'Bubba mods' that they end up dealing with on their jeeps. Well I am here to say that if you intend to use your jeep, then it will have to happen at some point. Some examples:

1. After flat towing my jeep to the U.P. / Shambhala, I noticed that the u joint caps that my silly father taped up had come undone. I mean come on Dad, use a little more tape here. (someone around here has met him/ probably tried to talk him low on some prices. Love you Dad!) But what is he going to do, drive 8 hours up here and press the joint for me? Nope. So I used a big rock and a socket to do it myself. Is it set in there correctly? Probably not. My jeep runs and drives.

2. While cruising deep in the boonies, a bolt fell out of the generator bracket. We used parachute cord to pull it twords the fender and hold the belt tight. Did I remember to put a bolt back in there for maybe 3 days? No I did not.  My jeep runs and drives.

3. Jeep stared to overheat. Whoops the thermostat is bad. I got a new one, but they didn't have a gasket. So I cut one using a steak knife and childrens safety scissors. It looked like crap so some aquarium sealant went on there as well. I also was missing my 1/8 inch drill bit. Two smaller holes didn't seem like a good idea so I just used the next closest size and sort of reamed out the hole. My jeep runs and drives.

4. Rain comes in the air vent. I get more wet from that then the lack of a full top. Duck tape goes over the hole instead of the hatch.

5. The rearview mirror fell off again, so that is now tied on with more cord. I do not intend to repair this problem ever again.
And on and on   ::) Poor jeep.

-Jesse
Its a jeep thing, but you would understand if you have ever lost your wallet.

Offline johnrb3b

  • SMF Administrator
  • Flatfender Master
  • *****
  • Posts: 906
  • Karma: +0/-0
  • No such thing as too many Jeeps - well maybe
    • View Profile
    • Jeeps and stuff
Re: Don't knock it until you have tried it
« Reply #1 on: October 04, 2012, 11:59:42 AM »
I love it.
Jesse, you are more honest than many of us.
I am just as guilty of "little temporary" repairs that tend to stay on the Jeep for months (or years) as the next guy.
I've removed some "Bubba"stuff from mine, but you should see my snow plow mount. The next guy is going to call me Bubba. Hey it works and moves lots of snow.
Keep the Jeeps alive and running  (even if it takes an occasional bandaid).
1946 2A - - - 1949 me - older than most of my Jeeps
1954 3B - - - 1957 Wagon - - - 2010 4-door JK
past Jeeps ---> '54 3B - no tub --- '59 3B - no engine
past addiction - VW ---> '69 bus --- '70 camper

Offline Carls_jeep

  • Flatfender Master
  • *****
  • Posts: 1746
  • Karma: +0/-0
  • ...
    • View Profile
Re: Don't knock it until you have tried it
« Reply #2 on: October 04, 2012, 04:02:41 PM »
Yep, you have to have a "get 'er done" attitude when your Jeeping in the boonies. You can't call a wrecker or walk to the store. It's a do or die situation.

Offline Gunslinger

  • Flatfender Master
  • *****
  • Posts: 942
  • Karma: +0/-0
  • Cj3a, M38A1,
    • View Profile
Re: Don't knock it until you have tried it
« Reply #3 on: October 05, 2012, 10:01:53 PM »
J.E.E.P.
Just
Enjoy
Every
Problem
Climbs trees, hides in the long grass, hangs out with wet dogs...

Offline Jesse

  • Willys Guru
  • ****
  • Posts: 298
  • Karma: +0/-0
    • View Profile
Re: Don't knock it until you have tried it
« Reply #4 on: October 07, 2012, 10:13:57 PM »
Jump
Every
Effin'

Um....
Phence

Which is what we usually do with my jeep every day. Ever seen the Great Escape?
Its a jeep thing, but you would understand if you have ever lost your wallet.

Offline Carls_jeep

  • Flatfender Master
  • *****
  • Posts: 1746
  • Karma: +0/-0
  • ...
    • View Profile
Re: Don't knock it until you have tried it
« Reply #5 on: October 08, 2012, 04:57:24 PM »
Don't try it until you knock it.

Offline HillBillE

  • Project Jeep (Newbie)
  • *
  • Posts: 37
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: Don't knock it until you have tried it
« Reply #6 on: October 27, 2012, 03:45:08 AM »
That's why I say the stuff I build is from "Rough Edge Fab"

I'll build a 'protoype' to see if it will work, nothing fancy, nothing ground smooth.

Well, they usually work, and I never bother to build a nice one, or clean up what I built once it's bolted on. :D

Lot of 'Rough Edges' on my CJ7
'46 CJ2A Undergoing Resto
'47 CJ2A Parts for resto
'52 CJ3A ser# 452 GB1 10197  "Ol' Sarge"
'80 CJ7 Summer Criuser
'00 TJ DD, trail rider and wheeler

Offline Carls_jeep

  • Flatfender Master
  • *****
  • Posts: 1746
  • Karma: +0/-0
  • ...
    • View Profile
Re: Don't knock it until you have tried it
« Reply #7 on: October 28, 2012, 11:47:23 AM »
I fall into that trap once in a while.