Here's an update on the stripped thread issue. I made a sleeve approximately the same height as the head and a gasket. I used an original type stud that was in real good shape and some new nuts I have but they are not hardened.

I then used the stud and nut with oiled threads to test the torque each hole will go to. With the thread oiled the torque value has to be reduced by 10 %. I used 60 ft lb for the setting on the torque wrench so that makes the real torque about 65 ft lb. To get an actual torque of 60 ft lb I would have had to set the torque wrench on 55 ft lb. OK, I started at the front of the block and worked my way to the rear. when I got to the "bad" hole, which is the one in the photo, it clicked at the 60 ft lb setting firmly. So, I raised the setting to 65 which gives 70 ft lb and it still clicked and was firm. I finished testing the rest of the holes at the 60 ft lb setting and none of them failed.
The only thing I can figure is the fine thread on the stud or the nut or both of them failed because the nut was locked solid on two studs and neither of those two hole failed the torque test. After all the years dealing with stuff like this I never am amazed but sometimes I am a little puzzled as to why stuff happens. Sometimes I spend to much time trying to trouble shoot a failure and figure out what happened and why when I should just get the job done. My curious mind won't let me let it go.
Well, anyway today I put some of the engine together and only need to put the pan and head on and tape up a few things and I can paint it then put the accessories on it. I'm thinking gloss black or maybe gray. I really like gray so it may be gray. I'll get some high temp black paint for the exh/intake manifolds. I may get the little bugger together this week and possibly in the Jeep next week end.
Man, I want to drive it so bad I can taste it.