After pestering the studs for about 3 hours I got them all out without breaking any. I did find a few of them bent and probably why it was hard to get the head off.
The old gasket is a Fel-Pro 7285 with copper on both sides and fiber between. I can't find one on line and the new # is 7285B with no copper. Not that I wanted one, just curious.
A few valves that are open show more wear in the guides than I like. Geez, I knew this was going to turn into a long project. Now I have to decide if I want to knurl the guides and do a valve job. I'll waddle back to the shop and clean the deck and start checking things closer.
It's a good thing I have these fellows to drink my beer and advise me on what to do, then again, maybe not. Well, back to work, there's things to break and parts to clean. Oh, BTW, Howard is the white bear, Ezekiel has the McGreggor tie on and the other one is Wilbur. Got to go, they, I mean we want another beer.
Calvin, you might want to show Lucille my advisory staff, she may get a chuckle out of it. I hope her bears don't take the bad habits mine have.
