The CJ3A Page CJ3B.info
« previous next »
Pages: [1]   Go Down

Author Topic: Clutch Cross Shaft  (Read 2176 times)

0 Members and 1 Guest are viewing this topic.

Offline Kirkski

  • Flatfender Master
  • *****
  • Posts: 526
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Clutch Cross Shaft
« on: September 11, 2015, 04:29:17 PM »
Anyone here rebuilt the Clutch Cross Shaft? One side of mine I can compress in and out, but the other is rock hard..

Any lessons learned would be helpful

Thanks in Advance
Kirk
Logged
'52 CJ-3A

Offline oldtime

  • Willys Guru
  • ****
  • Posts: 234
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: Clutch Cross Shaft
« Reply #1 on: September 11, 2015, 04:55:49 PM »
The end toward the transmission is spring loaded.
If the tube ends for the pivot ball studs are not worn; it is easily rebuild able.

Measure the distance from the tube to the CL of each lever pivot hole.
Weld the holes shut with mild steel.
Grind smooth.
Re-drill the holes to 5/16" diameter.
Logged
Pages: [1]   Go Up
« previous next »