The CJ3A Page CJ3B.info
« previous next »
Pages: [1]   Go Down

Author Topic: 3a engine supports problems  (Read 1483 times)

0 Members and 1 Guest are viewing this topic.

Offline Rab

  • Posts: 3
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
3a engine supports problems
« on: March 01, 2020, 10:24:23 AM »
Hello all
I’m in the process of putting together 3a power train and got everything
in. My problem is the steel engine mounts the PO had cut them off from the frame
I bought a set but turns out they weren’t for a 3a engine
Do any of you have a set that’s 100% for a  3a engine?
Logged
Nothing quite like old iron to work with

Offline oldtime

  • Willys Guru
  • ****
  • Posts: 234
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: 3a engine supports problems
« Reply #1 on: March 01, 2020, 03:46:34 PM »
Where you located ?
I probably have a set that I can cut off from one of my 3B frames.
I'll take a look.
Logged

Offline Rab

  • Posts: 3
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: 3a engine supports problems
« Reply #2 on: March 01, 2020, 08:52:31 PM »
Woodbury Tennessee about 70 miles south east of Nashville zip code is 37190
Logged
Nothing quite like old iron to work with

Offline oldtime

  • Willys Guru
  • ****
  • Posts: 234
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: 3a engine supports problems
« Reply #3 on: March 03, 2020, 10:30:23 AM »
This post belongs in the FS WTB category.

I have at least one frame that I plan to remove the original F-134 engine mounts (exact same as CJ3A mounts) to swap in a Dauntless.
So I'll be pulling off at least 1 good set and I could use a good set of Dauntless frame brackets if anyone has a set.
I'll send you a message.
Logged
Pages: [1]   Go Up
« previous next »