Hi Ryan,
Thanks for the compliment.
I have a Miller 125. It's very portable and compact. I use it with flux cored .35 wire. With very little practice, it's very easy to use. Wire feed rate set to about 1.5 and amp rate dialed to "C" when doing sheet metal. Initially, this may seem a little "hot", but I didn't seem to get good penetration when dialed back to "B".
1/4" to 3/8" welds, moving from one side of the patch to the other. If I'm in a hurry, I'll shoot some compressed air at the weld to cool it a little faster. Moving around when welding sheet metal helps to reduce warping.
This welder can also be used with shielding gas, but I've had good success with the flux core wire.
A welder is a must have for any workshop. Once you have one, you'll be looking everywhere for stuff to weld.
Tim