I decided today was the day so I tore into the job. I had suspected in the past that I had a leaking head gasket because it seemed to have a hydraulic lock when I tried to start the Jeep. The past few weeks I have noticed a strong gas smell in the garage from the Jeep so I started thinking the carb was leaking gas into the cylinders and when I pulled the carb there was a pool of gas in the manifold. Solved that issue but I will still replace the head gasket later and I did get the head gasket with fiber on both sides from Autozone.
I put the rebuilt carb on and installed the throttle cable but the new cable does not lock out with a twist of the knob as I remember the M38 did. I will make a collar with a thumb screw to lock the shaft out where I want it to solve that issue. I got the Jeep started and warmed up and adjusted the idle speed and bleed screw. Then I took her out for a test run and she ran just fine. No hesitation, so the accelerator pump is ok and no dead spots during acceleration tests. It looks like I did all the adjustments at rebuild correctly.
Yeeee Haaaa, I celebrated by pouring a Spaten Oktoberfest beer into a frosty mug and began drinking it as I type this thread. The weather is getting better here and I am also working on the trailer to haul the Jeep with.
Annabel Lee and I will be driving around the county a lot this summer. She sure likes driving in the mud more than I do. �:
