The CJ3A Page CJ3B.info

Author Topic: dipstick tube  (Read 2443 times)

0 Members and 1 Guest are viewing this topic.

Offline Macgraham

  • Flatfender Enthusiast
  • ***
  • Posts: 187
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
dipstick tube
« on: February 09, 2012, 01:05:02 PM »
Just getting engine ready to install, the dipstick tube seems to be fairly loose fit. Is there a way to seal it since there is no place for an o-ring? It came from another 134 so I thought it would be ok. Any suggestions?

Offline athawk11

  • SMF Administrator
  • Flatfender Master
  • *****
  • Posts: 2818
  • Karma: +0/-1
  • 1949 CJ3A
    • View Profile
Re: dipstick tube
« Reply #1 on: February 09, 2012, 02:33:08 PM »
Mac,

I used Permatex 2.  It's a plyable, non hardening seal.  Worked fine.  I also used it on my spines at the transfer case, and to seal threads on the bolts.

Tim

2-1949 CJ3As
1-1946 CJ2A

Offline p3ferris

  • Willys Guru
  • ****
  • Posts: 249
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: dipstick tube
« Reply #2 on: February 09, 2012, 09:33:14 PM »
Just push it down and fasten the clamp tight.

Offline turkehunt

  • Project Jeep (Newbie)
  • *
  • Posts: 45
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: dipstick tube
« Reply #3 on: February 19, 2012, 04:00:14 PM »
I have the same problem with no clamp @ the top The permatex 2 Sounds good  :)

Offline Jesse

  • Willys Guru
  • ****
  • Posts: 298
  • Karma: +0/-0
    • View Profile
Re: dipstick tube
« Reply #4 on: February 21, 2012, 10:04:40 PM »
I took a rounded over punch and put a few indents from the inside out on the bottom edge. Not huge dents, just 3 or 4 small ones for a tight fit. I was able to tap it in with a block of wood on the top and it is holding fine.

-Jesse
« Last Edit: February 21, 2012, 10:15:54 PM by Jesse »
Its a jeep thing, but you would understand if you have ever lost your wallet.

Offline Macgraham

  • Flatfender Enthusiast
  • ***
  • Posts: 187
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: dipstick tube
« Reply #5 on: February 21, 2012, 10:36:41 PM »
I took a socket which fit into the tube snugly and held it in the vise and worked the tube on and off and sideways and it made a good snug fit with the block. It worked out real well. thanks for you're help.