The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Shark49

Pages: [1] 2 3 ... 12
1
Your CJ-3B Project / Re: 1961 CJ3B "Gator"
« on: September 11, 2025, 03:11:31 PM »
all the same and radial tires at that.  Im going to check all of the mounts etc. for loose nuts.  But it feels as if something is off balance but under load it's fine.

2
Your CJ-3B Project / Re: 1961 CJ3B "Gator"
« on: September 09, 2025, 04:38:56 PM »
No big changes just getting it on the road for my first time.  The transfer case handles rattle some but there's something else going on when alifting off throttle and then back on with slight throttle the whole things vibrates

3
Your CJ-3B Project / Re: 1961 CJ3B "Gator"
« on: September 04, 2025, 06:34:29 AM »
YEs 2wd.  yokes are brand-new but ill check that. 

4
Your CJ-3B Project / Re: 1961 CJ3B "Gator"
« on: September 02, 2025, 10:46:13 AM »
I was just stating I have an OD.  The shifters rattle but its like a whole tranny thing when I lift off throttle and then reapply it will vibrate whole jeep

5
Your CJ-3B Project / Re: 1961 CJ3B "Gator"
« on: September 02, 2025, 07:14:36 AM »
Transmission question.  I have an overdrive on my 3 speed.  Works great.  However, when I am driving and I let off the gas it often shakes and rattles.  Is that a bad bearing?  Under throttle it's fine if a bit noisy.  I emptied and replaced the gear oil.

6
Your CJ-3B Project / Re: 1961 CJ3B "Gator"
« on: August 26, 2025, 08:16:31 AM »
I went through each wheel and readjusted the pads and while they were a bit off it wasn't enough to make a major change.  I got tired of crawling under it on hard concrete so I brought it to my local shop who works on classics and did a lot on my 61 Chevy apache.  In the meantime.  Pics of the jeep as it stands!  Getting the fold out windshield hardware powder coated.

7
Your CJ-3B Project / Re: 1963 CJ3B "Gator"
« on: August 13, 2025, 04:32:28 PM »
I put the original cap back on it and it did not change.  Ill try the shoes again.

Vintage Jeeper sells a cap with a threaded hole in the top in which you put a nipple and hose up to the remote reservoir.

8
Your CJ-3B Project / Re: 1963 CJ3B "Gator"
« on: August 13, 2025, 11:16:16 AM »
Yes I believe I did that when I installed all new brakes.  It still takes about two to three pumps to be firm.  I have bled them with my daughter assisting as well as using a compressor activated one. no leaks anywhere!

I may have mis-read the tape measure but it's the standard rear differential with the recessed drain at bottom. I need to tighten it. 

9
Your CJ-3B Project / Re: 1963 CJ3B "Gator"
« on: August 13, 2025, 07:07:08 AM »
Brakes are still squishy.  Can't figure it out.  May take it to a local mechanic.

On another note, what tool are guys using to drain the rear differential? It's a 7/8" square recessed plug and I cannot find anything online. 

10
Your CJ-3B Project / Re: 1963 CJ3B "Gator"
« on: July 08, 2025, 06:56:23 AM »
no cylinder leaks.  Im convinced it's a bubble seeing as it gets stiffer when I pump the pedal.

11
Your CJ-3B Project / Re: 1963 CJ3B "Gator"
« on: July 07, 2025, 08:05:11 AM »
essentially both.  It's soft and takes three pumps to get it to stop well.  So it's gotta be a pressure issue.  Maybe there's still a bubble somewhere.  Ill just bleed the crap out of them again.

12
Your CJ-3B Project / Re: 1963 CJ3B "Gator"
« on: July 06, 2025, 11:30:14 AM »
I got the lines all sealed tight after getting a Vintage Jeeper y-fitting and crush washer.  Now I have bled all of the lines not one bubble but can't seem to get a solid pedal.  I have the wildwood remote brake reservoir on it.  Any ideas?

13
Engine compartment / Re: F-Head Running Strange
« on: July 06, 2025, 09:26:01 AM »
y'all are going to love this!! So I figured out what it was.  The little bracket that holds the choke cable was loose.  When I gave it throttle it was pushing the choke and choking the engine.  Haha.  I fixed it but not happy with the bracket but they are impossible to find I guess.

14
Engine compartment / Re: F-Head Running Strange
« on: July 04, 2025, 01:21:59 PM »
Im gong to check the vac on it and go from there.

15
Engine compartment / Re: F-Head Running Strange
« on: June 30, 2025, 03:57:59 PM »
I found TDC and did the standard move the dizzy until it sounds good by ear.  It will rev up just fine sitting but doesn't like to drive and hesitates really bad.

Pages: [1] 2 3 ... 12