The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: JeepFever
« on: March 16, 2015, 11:45:52 PM »

I need to order a gasket set for sure,  probably a few valves,  and a set of piston rings (broke a couple when removing from #1 & #2 pistons).   I am wondering what size rings to order.   The pistons have 030 stamped on the top,  so that would seem to indicate this engine was bored .030 over.

I did some measurements with a 30 year old dial caliper, and snap gage.  My skills at measuring may not be extremely precise, but this is what I am seeing.

Top of piston:
3.131 to 3.136 

Bottom of piston:
3.141 to 3.152

Cylinder bore:
3.150 to 3.158

If these measurements are accurate,  should I order new rings,  .030 over?

Measuring tools:
Posted by: JeepFever
« on: March 16, 2015, 11:13:54 PM »

I wish this was the preservation of the original engine,� but the engine that I acquired with Hoover had a cracked cylinder.� . . I bought a replacement engine that "ran when I pulled it",� but the PO stored it outside under a tarp,� and it suffered water damage.

The engine would not turn over,� �this is what I found when I pulled off the head.


I was able to free up the engine,� but obviously with this much rust in the cylinders,� I needed to disassemble and check for the extent of the damage.

The pistons are removed, and the cylinders honed.� I am going to try to preserve this engine, without sending to machine shop.� It is very clean inside,� so was obviously rebuilt recently.� The crank and rod bearings are in very good condition.