After two years and a move 1600 miles to NE Montana, I finally completed my CJ3A go devil engine. About two hours into running I started getting steam into the exhaust plume and had a pretty good flow of a water mix coming out the muffler’s small low point drain hole at shut down. Very dishearten, I decided to pull the head. The engine was bored and sleeved back to standard size. I used the Felpro 7285B gasket with 5 studs under the removable oil filter and air tube brackets and bolts for the remainder of the fasteners. I torqued the head down in three steps. I’ve attached the photos that show a crack, between number 3 and 4. I believe this is the path for coolant into the combustion chamber of number 4.
The machinist supposedly leak checked it after machining and has a good reputation for working on classic motors. He is also 1600 miles away in West Texas.
I can only think that lock and stitch will fix this permanently, but the sleeve is adjacent to it. I also found the sleeve is .005 inches below the head surface. Shown in the second photo, which I believe is another issue
I have some money into this motor, so for now I will attempt a Best copper gasket, all studs for assembly, and lubricant on threads and a retire after the first couple of runs. Hopeful to stop the leak.
Open to any other suggestions.
Copy/paste so I can read your post.
Can't say for sure if issues like this crack are always existent and therefore should have been found or that could possibly be unnoticeable and then become a problem only after getting it running. I assume the sleeve should be flush - perhaps that's something that should have been caught and I can imagine it contributed to this.
I've read on the 2A forum about mixed reviews on the copper gasket. Installing one may or may not help.
https://www.thecj2apage.com/forums/antifreeze-up-from-center-stud-and-two-inner-plugs_topic55224_post573837.html?KW=copper+gasket#573837https://www.thecj2apage.com/forums/new-head-gasket_topic55235_post572682.html?KW=copper+gasket#572682https://www.thecj2apage.com/forums/head-gasket-replacement_topic54976_page2.html?KW=copper+gasketYou'll probably pick up on the suggestion to ensure flat alignment for the head and decking. But the sleeve and crack on yours is a different issue. Mark's suggestion may resolve the sleeve issue.
I did a quick search and noticed a few engine/machine shops in the Billings area (not sure where you are exactly). But checking out what's around you may be the best option moving forward as maybe opposed to the option of driving the block back to TX or (even worse) an all-expense paid trip for your previous machinist.