The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Chuck W.
« on: July 16, 2022, 12:02:25 PM »

A trick that I use is to pack a little grease into the groove around the spring, helps to keep the spring from coming out when the seal is driven into place.
Posted by: Rus Curtis
« on: July 15, 2022, 10:24:11 PM »

There's a small spring around the rubber part that makes contact with the shaft (the seal).  The rubber lip (where the spring is) goes towards the liquid (gear oil).  There are internet pictures of this.
Posted by: Tchara
« on: July 15, 2022, 11:53:56 AM »

Hi
Has anyone installed Ron Fitzpatrick double lipped oil seal? Before I install it, I want to be sure I know which way it goes in. I'm assuming the lip that protrudes from the seal goes towards the drive shaft side. Am I correct?