The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: oldtime
« on: March 03, 2020, 10:30:23 AM »

This post belongs in the FS WTB category.

I have at least one frame that I plan to remove the original F-134 engine mounts (exact same as CJ3A mounts) to swap in a Dauntless.
So I'll be pulling off at least 1 good set and I could use a good set of Dauntless frame brackets if anyone has a set.
I'll send you a message.
Posted by: Rab
« on: March 01, 2020, 08:52:31 PM »

Woodbury Tennessee about 70 miles south east of Nashville zip code is 37190
Posted by: oldtime
« on: March 01, 2020, 03:46:34 PM »

Where you located ?
I probably have a set that I can cut off from one of my 3B frames.
I'll take a look.
Posted by: Rab
« on: March 01, 2020, 10:24:23 AM »

Hello all
I’m in the process of putting together 3a power train and got everything
in. My problem is the steel engine mounts the PO had cut them off from the frame
I bought a set but turns out they weren’t for a 3a engine
Do any of you have a set that’s 100% for a  3a engine?