The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: RichardS
« on: November 22, 2019, 12:41:16 PM »

after it's installed in the flywheel
Posted by: Vincent
« on: November 22, 2019, 12:13:35 PM »

I’ve removed the pilot bushing from the flywheel. The flywheel will be resurfaced. The new bushing does not fit on the transmission pinion shaft. I assume it needs to be reamed. On page 119 of the mechanics manual, it says the inner diameter of the  clutch shaft bushing is .628”. This equates to 5/8. So do I ream the bushing to 5/8? And should I do it before or after installing in the flywheel?