The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Birddog7
« on: February 15, 2017, 10:54:21 PM »

Thanks Rick, that's what I was looking for. Now I have to go thru parts cans and find that spacer. Bought a new brake line kit try to get the short line to fit right. I figure I need a 3/8ths thick washer to clear the ubolts . The pic helped a lot.
Posted by: athawk11
« on: February 15, 2017, 10:19:38 PM »

Here's a photo.� Just looks like a chubby washer.� I think it raises the brake line fitting high enough to reduce brake line interference with the axle u-bolts.�

Posted by: Bob W
« on: February 15, 2017, 08:30:00 PM »

I believe it is just a special flat washer that is used as a spacer behind the tee.
Posted by: Birddog7
« on: February 15, 2017, 07:42:35 PM »

Need info on above spacer (group 24-7). It goes behind the brass brake line tee on the 3A & 3B Dana 25 axle