The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: PaulS
« on: July 02, 2016, 10:45:49 AM »

I have lots of pictures, too, but I didn't always take pictures where I should have.  I'm expecting to have trouble reassembling the clutch and the pedals and linkages around there...

When I pulled apart the engine, transmission, and transfer case, I was very diligent about using baggies.  And those (mostly) went back together without problems.  But I didn't use baggies when I pulled things off the frame.

-Pau
Posted by: specialty
« on: July 02, 2016, 02:56:59 AM »

I did the same thing with the bolts and some parts thinking 6 months down the road I could remember what I was doing when I forget what I did 10 minutes ago sometimes. I just took lots of pictures and emailed them to myself for reference. That helped more than anything. Things I missed I would google and find pictures to go by. Good luck.
Posted by: 1955CJ-5
« on: July 01, 2016, 10:26:47 PM »

Well, there you go....and your picture is better than mine..

I took a lot of pictures...sometimes I don't know what they were for...but they are fun to look at...

And I put all the nuts and bolts in baggies and then scribbled some gibberish on them assuming I would be able to decipher them months later....
Posted by: PaulS
« on: July 01, 2016, 01:53:08 PM »

Should have looked in my own archives before posting!



-Paul
Posted by: PaulS
« on: July 01, 2016, 01:49:21 PM »

Thanks!  I didn't measure to see if it would fit--I just tried to insert it, and I was wondering if it needed "persuasion".  But putting it underneath is easier, if that's where it's supposed to be!

It's been so long since I disassembled it, I'm sure I'll have lots more simple questions like this over the next few weeks, as it goes back together.

-Paul
Posted by: 1955CJ-5
« on: July 01, 2016, 10:38:50 AM »

Below the frame...

Will yours fit inside the frame?

Not a great picture but it's all I can find for now...

Randy

Posted by: PaulS
« on: July 01, 2016, 09:00:07 AM »

Does the tranny cross member bolt on below the frame, or does it fit inside the frame rails?

Thanks,

-Paul