The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: athawk11
« on: June 20, 2016, 11:27:38 PM »

The distributor is an "IAD 4008".
Posted by: elawson
« on: June 20, 2016, 11:03:00 PM »

The distributor itself (including the points and condenser) is one of the things that stays the same for 6V or 12V. 


The exact model number of the distributor--so you can get points and condenser--I can't tell
Posted by: CJPilot
« on: June 20, 2016, 10:02:23 PM »

You could look at a couple of bulbs to see what voltage the Jeep was set up for.
Posted by: athawk11
« on: June 20, 2016, 09:27:16 PM »

Welcome.
I can tell you that the distributor is original, but no way to tell what voltage you have based on these photos.  You may be able to find a part number or a voltage marking on your coil or condenser.   Pull the rotor and dust cap to locate the condenser.

Tim
Posted by: CJTHREEA
« on: June 20, 2016, 09:12:24 PM »

I am fixing an old Willys - I'm sure most of you can understand that I'm not 100% sure of what parts should stay and which parts should go.

Is there are good way to identify my distributor - and whether or not it has been converted to 12V or not?

Here are some pictures:

Can anyone help?