The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: ChrisD
« on: December 22, 2015, 11:22:18 AM »

Took the manifolds to my local machine shop. They had to drill out the holes where they bolt together and then re-surfaced it flat.
Posted by: ChrisD
« on: December 05, 2015, 09:36:29 PM »

John, thanks - I did not know about the thick washer. I will loosen the bolts and see if I can bolt up to the engine. I will probably be visiting the machine shop this week to get it planed. 
Posted by: Oilleaker1
« on: December 05, 2015, 05:19:09 PM »

There are 4 bolts where the intake and exhaust bolt together with a gasket. Can you loosen them and then bolt the pair up flat on the engine, then tighten the 4 ?  Also where the two bridge on the lower bolt line, a heavy thick washer is used there. If this fails, then you need to have the surface planed or milled. John
Posted by: ChrisD
« on: December 05, 2015, 04:11:23 PM »

Guys, I have new intake and exhaust manifolds that I am trying to install on my 1950 CJ3A. The manifolds will not align flat to the block once I bolt them together. I have already cracked one intake manifold because I did not check it before bolting it up.

Is there a trick I am missing??

Thanks,
Chris