The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Austin
« on: October 19, 2015, 07:25:00 AM »

I figured it out. I ended up making a bracket. I will post a picture later on this morning.
Posted by: aboyandhisdog
« on: October 18, 2015, 11:22:24 AM »

Austin,  you do have the rod and nuts that go through the bracket and alternator (generator) right?  Tim's photo is great but doesn't show the rod.  Could you be missing that?
Posted by: Austin
« on: October 18, 2015, 08:20:31 AM »

Somehow that bracket was used on my 3a go mount the alternator. I just can't figure out how they had it set up. It looks very similar to those brackets that aboyandhisdog posted. I can't imagine that I am missing something.
Posted by: aboyandhisdog
« on: October 17, 2015, 07:33:37 PM »

Ha - I had to discover all of this too when I converted to an alternator.  You'll need a pulley for the wide belt:  http://www.ebay.com/itm/361171729310?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

and then you need the new alternator bracket which will replace what you have:   http://www.ebay.com/itm/201282063943?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT


Of course I'm assuming you have a stock 3A set up.  Good luck - you will get there!   BTW...be advised you will need to research how best to wire it in.  I had a volt meter already so just ran the field wire to the switch and then a wire to the volt meter.  If you plan to keep your ammeter, the wiring is different.  I much prefer a voltmeter but it is up to you.  I bought the Delco 3 wire alternator.  I don't know much about the 1 wire alt.
Posted by: athawk11
« on: October 17, 2015, 07:22:00 PM »

I will add...This bracket is for a stock generator.  If you're using an alternator, you'll need a different set up.
Posted by: athawk11
« on: October 17, 2015, 07:19:41 PM »

Hope this helps...

Posted by: Austin
« on: October 17, 2015, 02:02:14 PM »

Here is the bracket
Posted by: Austin
« on: October 17, 2015, 02:01:01 PM »

I am trying to figure out how this bracket attaches to my motor and how it holds the alternator on. Everything else is looking good.