The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Tumbleweed
« on: June 11, 2014, 09:43:04 AM »

Thanks Tim,

This is very helpful information. I'm glad to be working on the 49 again!

George
Posted by: athawk11
« on: June 10, 2014, 10:39:57 PM »

Hi George.� Good to see you back in the saddle.

There are pads on the bottom mount radiators.� The only Willys I have that still has the original pads is the '46 2A.� They appear to be a little thicker than 1/4", and are made of the same material as the tub mounts.�

For ODie and Whitey, I used the cut up side wall of an old ply tire.� I believe the idea is to cushion the radiator, and at the same time, center the fan on the radiator shroud.� Adjust the pad thickness to achieve this centering.

Hope this helps.

Tim
Posted by: Tumbleweed
« on: June 10, 2014, 05:10:58 PM »

On the bottom mounted radiator, were there rubber pads to fit between the radiator and frame? I can't remember if I took 2 pads off.

Thanks,

George