The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: ZekeD
« on: January 09, 2014, 11:52:22 PM »

Advantage:  it is there and it works :D
Posted by: Mike S
« on: January 08, 2014, 09:51:24 PM »

The 9.25" HD clutch was an optional upgrade and can be retro-fitted to the standard 134 flywheel. You will have to drill and tap the flywheel, and I would rebalance it. It may require a slightly different clutch shaft. I seriously considered this upgrade for my 2A, but ended up putting a standard clutch in.

The HD clutch will withstand higher torque and wear and tear.
Posted by: Ryan_M
« on: January 08, 2014, 09:43:19 PM »

I've heard the heavy duty clutches can be a bear on the left leg as the pedal pushes a lot harder but I don't know for sure. You plan on doing any heavy duty rock crawling or county fair tractor pulls?
Posted by: 1955CJ-5
« on: January 08, 2014, 09:36:49 PM »

I think the 9 1/4" clutch is the heavy duty disc.....most CJ-5 f-heads used the 8 1/2 disc like the L-heads...

Posted by: athawk11
« on: January 08, 2014, 09:18:58 PM »

I was a little surprised to find that I have a CJ5 clutch assembly attached to my L134 -3A engine.� The clutch disc is 9 1/4". The flywheel has a 129 tooth ring gear.� The starter has a 9 tooth Bendix.� �The ring gear, clutch disc and Bendix look near new, and the set up functions fine.

Question...Is there any advantage, or disadvantage to this set up?