The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: 1955CJ-5
« on: November 20, 2013, 08:36:27 PM »

Well, just be sure to thread it through the Worm Hole, then you could be in both dimensions at once..

And what's another little drip, after all?
Posted by: ZekeD
« on: November 20, 2013, 08:18:32 PM »

I could twist it into a M�bius loop and then it would have only one side, and there couldn't be a question.....but I bet it would still leak!  :o

I should have bought two, but then................
Posted by: 1955CJ-5
« on: November 20, 2013, 05:49:57 PM »

I can't imagine which way it goes....you ordered two, right? ;D

The more I think about it the more it seems that it doesn't matter...

otherwise it would have come with instructions :D
Posted by: ZekeD
« on: November 20, 2013, 12:13:32 PM »

I have never seen a crush washer that was not solid (copper).  The oil pan washer from Walcks is solid on one side but wraps around a fiber washer with a gap on the other.   Which side goes toward the pan?   Does it matter?

Thanks
Zeke