The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: November 03, 2013, 04:52:57 PM »

If you have an L134 flat head engine with original manifolds and air cleaner crossover pipe you should have about a half an inch between the hood and the crossover pipe. Mine does and I am using the thick original gasket with my carb.
Posted by: Shalka04
« on: November 03, 2013, 12:56:56 AM »

So i'm going to swap out my Solex piece of crap tomorrow for my recently returned & Rebuilt Carter.  :-)  Life will be good again.

Here's the issue / problem.  The Carter is slightly taller then the Solaex, and as a result my airhorn tends to rub on the underside of the hood, when the carter is installed.
If I go with a regular gasket instead of the special V shaped one to go between the carb and the manifold I will avoid further rubbing.

How critical is that special  gasket with the V built into it?

Thanks for your thoughts,

-John