The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: 1955CJ-5
« on: September 01, 2013, 02:46:21 PM »

There is a repair kit for the steering pin, includes the bearings, seals, shaft and spacer and I can't remember what else...

http://walcks4wd.com/bell-crank-kit-78-2a-3a-3b-cj5.html

And you can buy just the inner crossover clutch/brake tube. It is the one that slides into the riveted frame bracket...i bought one and it was excellent quality and a good fit...

http://walcks4wd.com/cross-tube-brake-pedal.html

Walcks is having a 10% off sale this weekend!!
Posted by: CJPilot
« on: September 01, 2013, 12:37:32 PM »

Quote
since it's likely you will replace the old bellcrank pin and clutch/brake tube

That�s what I need to figure out.� I see Walcks has the clutch/brake tube welded in the bracket. Not to sure about the quality. Does anybody have just the tube so I don�t have to mess with the rivets and how about a grease-able version.� Is there a repair for the bellcrank pivot? Trying to get all this a done before the sandblasting so I can paint it before the frame starts to flash rust.


Steve
Posted by: 1955CJ-5
« on: September 01, 2013, 12:05:28 PM »

You might find a couple of wooden dowels that fit the clutch tube and steering bellcrank mount...or, since it's likely you will replace the old bellcrank pin and clutch/brake tube, you could just leave them in, if protecting the interior of the tubes is your goal...

Nice looking frame.....!
Posted by: CJPilot
« on: September 01, 2013, 09:18:10 AM »

The frame that came with my CJ3A was usable but had the typical Northeast pitting.� I happened to run across a pretty decent one.� The pitting is not as bad and it some how it followed me home.� Now I want to fix it up proper.


 I was planning on replacing the front and rear cross members on my original frame so I have them.� I have a good battery holder I�m also going to use.� My question is what should I do to the new frame before I have it sandblasted and painted? Should I do anything with the clutch pedal mount, the bell crank area?

Steve