The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: johnrb3b
« on: March 05, 2013, 12:51:40 PM »

General Rule of Thumb

NEVER throw anything away until you are COMPLETELY done with your Jeep project.

You never know what little part you'll find that you need. It's probably still on your parts vehicle.
We made that mistake twice - no, three times - on John's 3B project. Had to go to the forums and look for parts.
Posted by: ranchhopper
« on: March 03, 2013, 07:35:47 PM »

Motor mounts are good on this one Im having trouble resizing the pics I took of the frame I have five or six.
Posted by: F Bill
« on: March 03, 2013, 07:06:06 PM »

Plenty of guys need parts and pieces of frame so if you want to cut it up offer parts here...I for one need a set of motor mounts.
The rear bracing is often damaged, as is the front crossmember.

Put up a pic of the worse damaged areas and we can tell you more  about whether we would save it.
Posted by: ranchhopper
« on: March 03, 2013, 06:38:14 PM »

Im at the point in disassembling a parts CJ3A and Im down to the frame its not too bad some rust through where its boxed over the front axle on the inside of the frame should it be saved or just cut up. Im on the fence because I dont want a yard ornament thats going to sit here for years is it worth saving or just let it go?