The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: garage gnome
« on: March 01, 2013, 02:36:24 PM »

Should be 1/8" NPT to 1/4" tubing.
Posted by: BMIC
« on: March 01, 2013, 01:58:54 PM »

Thanks Tim, HUGE help.... there is always one small piece you forget to order that holds up a smooth weekend.
Posted by: athawk11
« on: March 01, 2013, 12:18:22 PM »

BMIC,

I believe the Napa # is 402X4. �If it's not that one, it's probably # 402X3

Grab one of their 1/4" brake lines and bring it to the counter with you. �If the brake line fits in the compression side of the elbow, this will be the right part to fit in the block.

Edit...And I believe either will work.  Just the wrench size on the elbow might be different.

Posted by: BMIC
« on: March 01, 2013, 11:51:08 AM »

Little help please.... Does anyone know the size of the brass elbow fitting that attaches the oil pressure line to the block? Napa part #?
Thanks