The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Gunslinger
« on: September 30, 2012, 09:37:27 AM »

I guess I'd go ahead and repair the frame the way it needs to be by taking all of the attachements off and doing the structural work first, then measure up the other side, drivers side and clamp everything in place good and tight.  Measure three times and weld once.  If you are off by 1/16 or so it should be ok, not sure any more than that would be good.
Posted by: rocketeer
« on: September 29, 2012, 09:44:17 PM »

Match it up to the other side.

Larry
Posted by: 3aJeeper
« on: September 29, 2012, 11:29:57 AM »

I've got to replace the passenger rear spring bracket, including a small part of the frame it attaches to. The front bracket is in good shape. any tips on installing the new bracket so that the spring is in the correct alignment? Or will the shackle compensate for any minor deviations?