The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Redrockman
« on: August 05, 2012, 08:23:17 PM »

Looks like you have over 1/2 of the hole there, my suggestion is to get a grade 8/"AN" washer and trim it to fit the casting before you put the bolt/lock washer back in the case.

"AN" washers are the same thickness for better load under the bolt head when you torque the bolt, it can also be welded using a carbon arc rod in the hole for a temporary plug while welding it using a Stainless Steel welding rod on an aluminum plate, then all you do is knock out the carbon plug and chase the hole with a drill bit.


My .02 worth'

Redrockman
Posted by: NoCoWillys
« on: August 05, 2012, 06:51:45 PM »

Well it seems my poor jeep has had a bit of a rough life. �Something happened to the rear bearing cap to break part of the flange of one of the bolts that holds it to the case.



Is this now a paper weight or do you think I can get away with using it? �Probably just looking for leaks if I do use it? �Thoughts? �I've seen a few places I can get a replacement, most are omix parts. �Would they be OK or should I shell out the 2-3 times the cost for an original spicer?  :-/