The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: August 04, 2012, 11:22:53 PM »

It's normal to be hard to move by hand with it assembled in the tranny or even in your hand. I wouldn't be to concerned as long as it moves completely into each gear. Try putting the shift tower on temporarily and shifting it through the gears and that should tell you what you want to know. Be sure to squirt some oil on the synchro assy before you do the shift test.
Posted by: NoCoWillys
« on: August 04, 2012, 09:59:53 PM »

So I just finished my rebuild, I think, but the synchronizer/hub between 2nd and 3rd is really stiff.  It will slide, but only with some encouragement.  Without the springs and plates, it has a real nice fit.  This is the old one since I didn't really see that much wear on it.  I think it had been replaced at some point. Now I haven't tried with the stick yet,  could it just be it's that stiff with all the brand new springs and everything around it?  The 3 holes are lined up for the plates to go into.