The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Tumbleweed
« on: July 25, 2012, 02:59:13 PM »

That is what I figured. Can't go wrong if you put it in like you took it out unless it was broken to begin with!

I think the ID of the bushing is .625 / .627. I'll do some checking on the mating shaft to see if mine is worn too much. Not sure what that dimension should be.

Thanks.......
Posted by: Carls_jeep
« on: July 25, 2012, 12:06:18 PM »

I would put it as deep as the one you removed. Also, be sure to put the shaft that fits into the bushing in it to be sure it doesn't need to be reamed out.
Posted by: Tumbleweed
« on: July 25, 2012, 11:49:05 AM »

I have removed the brass bushing from the output shat and was wondering if there is a specified depth for the new bushing. My plan is just to press it in as deep as the one I took out. Just wondering.....

Tumbleweed...........