The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Bedrock
« on: June 27, 2012, 10:48:08 AM »

As Carl said, the threads in the block are coarse, so the use of bolts could change the torque specs as compared to studs, which have nuts torqued onto a fine thread  When I got my '51 3A it had bolts, and there had been a leaking problem.  I took off the head because I wanted to replace the bolts with studs, and there were cracks in the block radiating out from about 5 of the stud holes.  A couple of these cracks had opened up pretty well.  I don't know whether the use of bolts, and then over torqueing, caused the cracks.  Maybe the PO tried to stop the leaking by applying more torque to the bolts.  I ended up getting another block.

My suggestion is to use studs.  That is what was originally used, and I think when in doubt, it is generally safer go with how things were originally designed.
Posted by: Carls_jeep
« on: June 24, 2012, 08:40:53 PM »

The bolts have to be sealed at the threads so you will have to put sealer on the thread. Since the threads in the block are coarse and the thread on the stud for the nuts are fine there is an issue there. When you put the stud in the block and snug it some then the torquing force is spread evenly over the length of the thread in the block. Cast iron is not real strong so torquing a bolt in the cast iron block may cause the thread to fail and strip.

These blocks are soft cast iron and I wouldn't trust using bolts in place of the studs. If you want to use bolts then a grade 8 bolt with hard washers is what you want.
Posted by: Shalka04
« on: June 24, 2012, 06:36:29 PM »

I wanted to see if there were any thoughts or experience replacing studs with bolts?  If it's not an issue other then paying attention to their elngth, can I get away with off the shelf grade 8 bolts or do I need some weird heat treatment item.

Regards,
-John