The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: CJPilot
« on: May 15, 2012, 03:08:41 PM »

Mac �Good way to prime! �I have used a small pump up sprayer from a box store to do the same. It worked very well.

Steve �

1950 CJ3A
Posted by: Macgraham
« on: May 15, 2012, 01:39:45 PM »

I think this worked really well. I had to drop the pan because of a spotweld leak right after I finished priming and there was oil dripping down from all the lower bearings. It also filled the oil filter can. It would probably work the way you describe as well if you can close up the system.
Posted by: CJJay
« on: May 15, 2012, 01:25:13 PM »

This is cool, I was thinking about useing the line from the top of the oil canister to force the oil into the pump. Do you think this will work as well?
Posted by: Carls_jeep
« on: May 07, 2012, 01:18:05 PM »

Your Jeep is looking good and I do like the pressure lube system.
Posted by: calvinhunt
« on: May 07, 2012, 01:25:24 AM »

Quote
Imust have filled the gun 5 or 6 times. I tried to send a photo but it didn't work. Will email it to you Carl.
Mac sent the photos of his grease gun application for priming his engine to me, as well.  I posted them here without his permission.  Hope we're still friends.


Posted by: Macgraham
« on: May 06, 2012, 10:33:56 PM »

Imust have filled the gun 5 or 6 times. I tried to send a photo but it didn't work. Will email it to you Carl.
Posted by: Carls_jeep
« on: May 06, 2012, 07:44:51 PM »

 ;D don't you love it when one thing after another starts pulling your rope. How many times did you have to fill the grease gun with oil to prime the galleys?
Posted by: Macgraham
« on: May 05, 2012, 07:08:41 PM »

I tried the grease gun idea to prime my 134 oil system and it really worked well. First thing it told me was that I forgot to put the plug in the oil filter can. Took longer to clean the gun than to put the 4 quarts in. It also told me that I had a leak in the oil pan. One of the spot welds had cracked where the guard was spotted on. Fortunately I had another pan that is good so no better time to do it than now. When I dropped the old pan you could see that the bearings had lots of oil from the grease gun pump, lots o[IMG]http://i106f oil dripping down.<a href="http://