Posted by: Comanche_County
« on: May 02, 2012, 08:23:05 PM »Thanks for the tips and advice, as usual fellas!
I got it going just a few minutes ago. Took it around the block and it ran just fine.
Bill, AT, I checked everything you mentioned. The PVC valve was clogged, got that cleaned up, also blew out the hard line to the tank. I believe the culprit was very small bits of rust clogging the carb and the fuel pressure regulator. Cleaned out both and rechecked the timing and all ignition components. BTW, the fuel pump works great, psi is low in my uneducated opinion, but volume it there, it puts out a lot of gas, more than the engine can burn I'm certain.
Bill, I hear you on the timing. I'm adjusting the timing by turning the distro to where it starts easiest and then listening closely to where it idles and revs the smoothest. But when I crack the distro cap, it just seems to alway come out right after the point where I get the compression blowing past my finger in the spark plug hole. I guess its not a precise way to gauge TDC. But I've got it where it seems to run the best.
I'm chalking this one up to a rusty tank,,,,definitely needs a new one.
Thanks fellas!
I got it going just a few minutes ago. Took it around the block and it ran just fine.
Bill, AT, I checked everything you mentioned. The PVC valve was clogged, got that cleaned up, also blew out the hard line to the tank. I believe the culprit was very small bits of rust clogging the carb and the fuel pressure regulator. Cleaned out both and rechecked the timing and all ignition components. BTW, the fuel pump works great, psi is low in my uneducated opinion, but volume it there, it puts out a lot of gas, more than the engine can burn I'm certain.
Bill, I hear you on the timing. I'm adjusting the timing by turning the distro to where it starts easiest and then listening closely to where it idles and revs the smoothest. But when I crack the distro cap, it just seems to alway come out right after the point where I get the compression blowing past my finger in the spark plug hole. I guess its not a precise way to gauge TDC. But I've got it where it seems to run the best.
I'm chalking this one up to a rusty tank,,,,definitely needs a new one.
Thanks fellas!